iRobot Roomba error 42

Error 42 in iRobot Roomba - A Guide to Fix

Have you ever encountered an Error 42 alert in your iRobot Roomba vacuum cleaner? If the answer is yes, you must be looking for ways to fix that. Read on to find out more about the cause and the solution for the same.

Cause

Error 42 of iRobot Roomba typically occurs when there is a technical fault. It can be because of faulty wiring, battery related issues, dirt pickup sensors, etc. Unfortunately, it cannot be fixed automatically and has to be dealt with manually.

Solution

Start the troubleshooting by doing the following:

• Check the filter, if it is blocked it can lead to Error 42. Clean the filter and see if the alert shows up again.
• Examine the dirt pickup sensor and remove any dirt or debris. Make sure there is no infringement or clogging as it can block the rotating brushes.
• If the battery is not placed properly it can trigger the alert. Check the battery and make sure it is properly set and the contacts are connected.
• You can also reset the device from the power button. You can place it in the charging dock station and press and hold the power button. Then wait until you hear the beep sound which confirms successful reset.

These steps should be able to fix the Error 42 alert in iRobot Roomba. However, if these steps do not help, it is best to contact the technicians for technical assistance.

Conclusion

In conclusion, the Error 42 in iRobot Roomba can be caused due to multiple reasons such as faulty wiring, battery issues and dirt sensor issues. The best way to troubleshoot the same is to reset the device and check the filter, dirt pickup sensor, and battery. You may seek professional help if the issue still persists.

We hope this guide was helpful and provided you with the necessary information about the Error 42 alert in iRobot Roomba. If you need any further help, please leave us a comment and we will get back to you as soon as possible.